WASMSR SMT Reverse Spacers Improve PCB Assembly Efficiency

2026-10-31

The WA-SMSR series of SMT reverse steel standoffs is designed to balance top-side soldering with bottom-side assembly in high-density printed-circuit-board production. The components are intended for automated placement lines and combine a reverse-mount design with mechanical and thermal specifications suited to industrial electronics. Product information lists the series as an active-production component with an expected service life of more than 10 years.

Reverse mounting for automated assembly

The WA-SMSR standoff uses a reverse-mount design that secures through a 3.2 mm hole. On a standard 1.6 mm PCB, it supports spacing distances from 1 mm to 10 mm. A removable polyimide tape is supplied to simplify the surface-mount process and assist precise positioning during automated placement and soldering.

The design is aimed at production environments in which top-side soldering and bottom-side assembly must be coordinated without disrupting line flow. Pin lengths range from 2.6 mm to 11.6 mm, allowing the part to accommodate different application gaps.

Key specifications

The standoff is made of steel with a tin-plated surface. Its operating temperature range is -55°C to +150°C, and the specified solder paste thickness is 150 μm. The table below summarizes the published specifications.

Parameter	Specification
Material	Steel, tin-plated
Hole diameter (Ø f)	3.2 mm
Operating temperature	-55°C to +150°C
Pin length	2.6 mm to 11.6 mm
Solder paste thickness	150 μm

Production reliability

Product information describes the WA-SMSR series as an active-production component with retention and torque performance intended for demanding industrial environments. Its expected service life exceeds 10 years, according to the published specifications.

The combination of steel construction, tin plating, and a wide operating-temperature range is intended to support reliable performance in long-term industrial projects and to maintain process consistency across production runs.

Frequently Asked Questions

Are WA-SMSR standoffs suitable for all PCB thicknesses?

The series is designed primarily for standard 1.6 mm PCBs, where it supports mounting distances from 1 mm to 10 mm. For other board thicknesses, users should verify pin length and actual application clearance before selection.

Does the polyimide tape require special treatment before soldering?

The tape is designed for immediate removal and is used to aid positioning during automated placement. It should be removed before or after reflow soldering according to the specific process flow.

Is the product stable at high temperatures?

Yes. The operating temperature range is -55°C to +150°C, which meets the requirements of most industrial-grade electronic equipment in demanding environments.

Assemblea del bordo di PCBA

Assemblaggio PCB prototipo

Fabbricazione a partire da prodotti di base

PCB rigidi

PCB HDI

Bordo flessibile del PWB

Assemblea rigida del PWB della flessione

Assemblea del PWB di SMT

Fornitura di componenti per PCB

Assemblea automobilistica del PWB

Assemblaggio PCB Industriali

Apparecchio medico PCBA

PCBA per la comunicazione